--- trunk/libf/dyn3d/conf_dat2d.f90	2010/03/05 16:43:45	25
+++ trunk/dyn3d/conf_dat2d.f	2015/02/03 19:30:48	122
@@ -1,14 +1,13 @@
 module conf_dat2d_m
 
-  ! From conf_dat2d.F, version 1.2 2006/01/27 15:14:22
-
   IMPLICIT NONE
 
 contains
 
   SUBROUTINE conf_dat2d(xd, yd, xf, yf, champd, interbar)
 
-    ! Auteur : P. Le Van
+    ! From conf_dat2d.F, version 1.2 2006/01/27 15:14:22
+    ! Author : P. Le Van
 
     ! Ce sous-programme configure le champ de données 2D 'champd' et
     ! les longitudes et latitudes de telle façon qu'on ait - pi à pi
@@ -27,8 +26,7 @@
     ! If required, the longitudes and latitudes are finally replaced
     ! by their mid-values.
 
-    use numer_rec, only: assert_eq
-    use comconst, only: pi
+    use nr_util, only: assert_eq, pi
 
     REAL, intent(in):: xd(:)
     ! (longitudes, in degrees or radians, in increasing order, from 0°
@@ -38,12 +36,11 @@
     ! (latitudes, in degrees or radians, in increasing or decreasing
     ! order, from pole to pole)
 
-    LOGICAL, intent(in), optional:: interbar
     REAL, intent(out):: xf(:), yf(:) ! longitudes and latitudes, in rad
     REAL, intent(inout):: champd(:, :)
+    LOGICAL, intent(in), optional:: interbar
 
-    ! Variables locales:
-
+    ! Local:
     INTEGER  lons, lats
     LOGICAL radianlon ! "xd" is in degrees
     logical invlon ! "xd" contains longitudes between 0 and 2 pi
@@ -106,8 +103,8 @@
        end do
 
        xf(i:) = xf(i:) - 2 * pi
-       xf(:) = cshift(xf, shift=i - 1)
-       champd(:, :) = cshift(champd, shift=i - 1)
+       xf(:) = cshift(xf, shift = i - 1)
+       champd(:, :) = cshift(champd, shift = i - 1)
     ENDIF
 
     IF (yd(1) < yd(lats)) THEN