Ignore:
Timestamp:
02/13/15 12:48:42 (9 years ago)
Author:
jgipsl
Message:

Removed parameter SLOWPROC_HEIGHT from orchidee.def : this parameter is only used when running without stomate. The default values in the model for this parameter is considered better than the value that were set here.

Orchidee project group

Location:
CONFIG/UNIFORM/v6/LMDZOR_v6/GENERAL/PARAM
Files:
2 edited

Legend:

Unmodified
Added
Removed

  • CONFIG/UNIFORM/v6/LMDZOR_v6/GENERAL/PARAM/orchidee.def_CWRR

    r2410 r2414  
    8383STOMATE_OK_CO2 = y 
    8484 
    85 # Prescribed height of vegetation 
    86 # default = 0., 30., 30., 20., 20., 20., 15., 15., 15., .5, .6, 1.0, 1.0 
    87 SLOWPROC_HEIGHT__01 = 0. 
    88 SLOWPROC_HEIGHT__02 = 50. 
    89 SLOWPROC_HEIGHT__03 = 50. 
    90 SLOWPROC_HEIGHT__04 = 30. 
    91 SLOWPROC_HEIGHT__05 = 30. 
    92 SLOWPROC_HEIGHT__06 = 30. 
    93 SLOWPROC_HEIGHT__07 = 20. 
    94 SLOWPROC_HEIGHT__08 = 20. 
    95 SLOWPROC_HEIGHT__09 = 20. 
    96 SLOWPROC_HEIGHT__10 = .2 
    97 SLOWPROC_HEIGHT__11 = .2 
    98 SLOWPROC_HEIGHT__12 = .4 
    99 SLOWPROC_HEIGHT__13 = .4 
    100  
    10185# Use cdrag coefficient from gcm 
    10286CDRAG_FROM_GCM = y 

  • CONFIG/UNIFORM/v6/LMDZOR_v6/GENERAL/PARAM/orchidee.def_Choi

    r2410 r2414  
    8383STOMATE_OK_CO2 = y 
    8484 
    85 # Prescribed height of vegetation 
    86 # default = 0., 30., 30., 20., 20., 20., 15., 15., 15., .5, .6, 1.0, 1.0 
    87 SLOWPROC_HEIGHT__01 = 0. 
    88 SLOWPROC_HEIGHT__02 = 50. 
    89 SLOWPROC_HEIGHT__03 = 50. 
    90 SLOWPROC_HEIGHT__04 = 30. 
    91 SLOWPROC_HEIGHT__05 = 30. 
    92 SLOWPROC_HEIGHT__06 = 30. 
    93 SLOWPROC_HEIGHT__07 = 20. 
    94 SLOWPROC_HEIGHT__08 = 20. 
    95 SLOWPROC_HEIGHT__09 = 20. 
    96 SLOWPROC_HEIGHT__10 = .2 
    97 SLOWPROC_HEIGHT__11 = .2 
    98 SLOWPROC_HEIGHT__12 = .4 
    99 SLOWPROC_HEIGHT__13 = .4 
    100  
    10185# Use cdrag coefficient from gcm 
    10286CDRAG_FROM_GCM = y 
Note: See TracChangeset for help on using the changeset viewer.