Changes between Version 55 and Version 56 of Doc/CheckDebug

Timestamp:

11/08/19 10:41:21 (4 years ago)

Author:

acosce

Comment:

--

Doc/CheckDebug

@@ -89 +89 @@
 ### TimeSeries_Checker ###
 
-The `TimeSeries_Checker.job` can be used in diagnostic mode to check if all time series have been successfully created. Read more further below [#Startorrestartpostprocessingjobs1].
+The `TimeSeries_Checker.job` can be used in diagnostic mode to check if all time series have been successfully created. Read more further [#Startorrestartpostprocessingjobs1 below].
 ### SE_Checker ###
 
-See further below [#SE_Checker.jobrecommendedmethod].
+See further [#SE_Checker.jobrecommendedmethod below].
 
 
@@ -229 +229 @@
 
 
-## Start or restart post processing jobs ##
-Please look at the next paragraph.
-
-
 # Start or restart post processing jobs #
 
@@ -255 +251 @@
   
  
-
-[[NoteBox(warn, Before submitting a post processing job at TGCC (`rebuild_fromWorkdir.job`\, `pack_debug.job`\, `pack_output.job`\, `pack_restart.job`\, `monitoring.job`\, `create_ts.job`\, `create_se.job`) you must make sure that the submission group in present in the job header (#MSUB -A genxxxx). If it isn't\, add it., 600px)]]
 ## Restart REBUILD ##
 [[NoteBox(tip,Most of the configuration has no more a Rebuild step\, due to the use of parallel I/O (done with XIOS). In most of the case\, you can go to the next step. The rebuild step is sill use in some ORCHIDEE configurations, 600px)]]
@@ -354 +348 @@
 
    * Copy the `libIGCM/TimeSeries_Checker.job` file to the experiment directory or to the dedicated directory besides COMP and config.card as minimum
-   * Since tag libIGCM_v2.8 you do not need to modify the TimeSeries_Checker.job anymore. By default it takes the variables from config.card. 
+   * You do not need to modify the TimeSeries_Checker.job anymore. By default it takes the variables from config.card. 
    * Check the value of !TimeSeriesCompleted in run.card. For a complete check set :
 {{{