source:
NEMO/trunk/doc/namelists/namctl
@
14288
Last change on this file since 14288 was 12377, checked in by acc, 4 years ago | |
---|---|
|
|
File size: 2.0 KB |
Rev | Line | |
---|---|---|
[707] | 1 | !----------------------------------------------------------------------- |
[10075] | 2 | &namctl ! Control prints (default: OFF) |
[707] | 3 | !----------------------------------------------------------------------- |
[12377] | 4 | sn_cfctl%l_glochk = .FALSE. ! Range sanity checks are local (F) or global (T). Set T for debugging only |
5 | sn_cfctl%l_allon = .FALSE. ! IF T activate all options. If F deactivate all unless l_config is T | |
[10601] | 6 | sn_cfctl%l_config = .TRUE. ! IF .true. then control which reports are written with the following |
7 | sn_cfctl%l_runstat = .FALSE. ! switches and which areas produce reports with the proc integer settings. | |
8 | sn_cfctl%l_trcstat = .FALSE. ! The default settings for the proc integers should ensure | |
9 | sn_cfctl%l_oceout = .FALSE. ! that all areas report. | |
10 | sn_cfctl%l_layout = .FALSE. ! | |
[12377] | 11 | sn_cfctl%l_prtctl = .FALSE. ! |
12 | sn_cfctl%l_prttrc = .FALSE. ! | |
13 | sn_cfctl%l_oasout = .FALSE. ! | |
[10601] | 14 | sn_cfctl%procmin = 0 ! Minimum area number for reporting [default:0] |
15 | sn_cfctl%procmax = 1000000 ! Maximum area number for reporting [default:1000000] | |
16 | sn_cfctl%procincr = 1 ! Increment for optional subsetting of areas [default:1] | |
17 | sn_cfctl%ptimincr = 1 ! Timestep increment for writing time step progress info | |
[2282] | 18 | nn_print = 0 ! level of print (0 no extra print) |
[2540] | 19 | nn_ictls = 0 ! start i indice of control sum (use to compare mono versus |
20 | nn_ictle = 0 ! end i indice of control sum multi processor runs | |
21 | nn_jctls = 0 ! start j indice of control over a subdomain) | |
22 | nn_jctle = 0 ! end j indice of control | |
23 | nn_isplt = 1 ! number of processors in i-direction | |
24 | nn_jsplt = 1 ! number of processors in j-direction | |
[9019] | 25 | ln_timing = .false. ! timing by routine write out in timing.output file |
26 | ln_diacfl = .false. ! CFL diagnostics write out in cfl_diagnostics.ascii | |
[2540] | 27 | / |
Note: See TracBrowser
for help on using the repository browser.